WhelenNDealin
Member
I got an Edge Freedom a little while ago. I believe that it had an Opticom emitter at one point. There's a 400 series strobe in the middle of the bar. A power cable runs from it to outside of the bar. I'm on the fence as to how to proceed. Part of me wants to connect that cable to a strobe power source. However, I don't like the idea of an exposed power source in terms of shock risk. I could house it in something.
My other course of action is replacing it. There are two LR11 takedowns to either side of the strobe tube. I was thinking of putting a couple center modules in; one r/w and one b/w. They're the old modules without optics.
The issue is then with the takedowns and how to mount those as their size prevents me from putting in two lightheads. The bar used a couple of the light head clips cut in half vertically with a bandsaw. One's still fine and the other's busted. I'm getting a bunch of clips soon and cutting one in half is doable.
So, how can I proceed with the strobe option and how to proceed with the LED option?
Any 2¢ would be much appreciated.
My other course of action is replacing it. There are two LR11 takedowns to either side of the strobe tube. I was thinking of putting a couple center modules in; one r/w and one b/w. They're the old modules without optics.
The issue is then with the takedowns and how to mount those as their size prevents me from putting in two lightheads. The bar used a couple of the light head clips cut in half vertically with a bandsaw. One's still fine and the other's busted. I'm getting a bunch of clips soon and cutting one in half is doable.
So, how can I proceed with the strobe option and how to proceed with the LED option?
Any 2¢ would be much appreciated.