Tango7
Member
So, after a long wait ($$) I finally got the small parts to accompany the OBD Interface for my Cantrol. Using a hodgepodge of spacers, standoffs and a combination of adapted IC standoffs I got the board installed and recognized. (If it's ugly but it works and it's hidden, who cares).
So I opened up the cable that I'd purchase from a guy who was upgrading from Cantrol to Core, and discovered I had a problem:
I don't know if the guys sent me his Core cord instead of the Cantrol, or if (as I found out surfing for answers last night) his cable was for the "old style" ODB interface which apparently used 6 pins instead of the current 8.
I found a guy who said he'd trade for the cable, but in case he can't find it the title of this post states my request. I can get a 15 foot OBDII cord that's fully populated and run the appropriate pins to the appropriate plugs in the Interface, but the Whelen docs only show a generic diagram for all models:
Thanks all.
So I opened up the cable that I'd purchase from a guy who was upgrading from Cantrol to Core, and discovered I had a problem:
I don't know if the guys sent me his Core cord instead of the Cantrol, or if (as I found out surfing for answers last night) his cable was for the "old style" ODB interface which apparently used 6 pins instead of the current 8.
I found a guy who said he'd trade for the cable, but in case he can't find it the title of this post states my request. I can get a 15 foot OBDII cord that's fully populated and run the appropriate pins to the appropriate plugs in the Interface, but the Whelen docs only show a generic diagram for all models:
Thanks all.