Scoot163
Member
I am a mechanical rotator, halogen light guy. I was given the above Liberty bars to work on, one to keep, the other for the guy who gave them to me.
Tony gave me some help in another thread, ( starting a new one 'cause I felt I was hijacking the other), so I bought a WeCan controller module, hooked it up per the instructions and......nothing. Not even a blink.
I checked the fuses, checked to see power going into both bars. I downloaded the WeCan programming software, plugged in the controller and it was recognized immediately. The module says "factory default" on it but I saw no patterns showing in the software program.
I know there is a possibility the I/O boards could be bad. Anything else I can try? Another member mentioned flashing the I/O board with a blank pattern, then creating a new lightbar and pattern and loading that. Looking at it, it wasn't real apparent on how to use the programming software. Any help appreciated.
Do the shield wires need to be connected for the bar to work? I did connect them but nothing happened.
Thanks,
Rich
Tony gave me some help in another thread, ( starting a new one 'cause I felt I was hijacking the other), so I bought a WeCan controller module, hooked it up per the instructions and......nothing. Not even a blink.
I checked the fuses, checked to see power going into both bars. I downloaded the WeCan programming software, plugged in the controller and it was recognized immediately. The module says "factory default" on it but I saw no patterns showing in the software program.
I know there is a possibility the I/O boards could be bad. Anything else I can try? Another member mentioned flashing the I/O board with a blank pattern, then creating a new lightbar and pattern and loading that. Looking at it, it wasn't real apparent on how to use the programming software. Any help appreciated.
Do the shield wires need to be connected for the bar to work? I did connect them but nothing happened.
Thanks,
Rich