k9cop116
Member
After rigging out several cars for a local agency (an agency that could not afford to purchase vehicle specific mounts, AND requested no permanant holes / signs that equipment had been mounted in their Lease vehicles) I came up with a cheap and easy was to mount lightweight LED's to the front and rear headliners.....
You simply cut a length of wire coat-hanger (yes....coat-hanger) and bend one end in a "U" shape, which is captured by the side mounting screw on the side of the light head. Then you poke the wire through the hedliner, then bend it over 90 degrees on the inside of the headliner. Do that on the other side of the light...and like magic, your light is held in place, tight against the headliner. When you remove the light....the hole where the wire pierced the headliner is so small that you'll never see it. I've done this on the front and rear headliners.
crappy cell phone pics..
You simply cut a length of wire coat-hanger (yes....coat-hanger) and bend one end in a "U" shape, which is captured by the side mounting screw on the side of the light head. Then you poke the wire through the hedliner, then bend it over 90 degrees on the inside of the headliner. Do that on the other side of the light...and like magic, your light is held in place, tight against the headliner. When you remove the light....the hole where the wire pierced the headliner is so small that you'll never see it. I've done this on the front and rear headliners.
crappy cell phone pics..