Bbeja81689
Member
Good evening,
I recently installed a fed sig smart siren. Everything was working perfectly fine, no issues whatsoever. Recently, the inline fuse that goes to the wiring harness keeps tripping. The only wires connected from the harness are the hot, ground and 2 speaker wires. I have a 20a fuse as suggest by the install manual. The main hot feed from the battery (resetable 50a fuse) as required from the manual does not trip. Also, I am only running maybe 10 led lights which have minimum draw, so I doubt it could be an amperage overload, but anything is possible.
I'm trying to figure out if there is an internal fault in the unit and/or how I can self diagnose what the issue could be. Any direction would be greatly appreciated.
I recently installed a fed sig smart siren. Everything was working perfectly fine, no issues whatsoever. Recently, the inline fuse that goes to the wiring harness keeps tripping. The only wires connected from the harness are the hot, ground and 2 speaker wires. I have a 20a fuse as suggest by the install manual. The main hot feed from the battery (resetable 50a fuse) as required from the manual does not trip. Also, I am only running maybe 10 led lights which have minimum draw, so I doubt it could be an amperage overload, but anything is possible.
I'm trying to figure out if there is an internal fault in the unit and/or how I can self diagnose what the issue could be. Any direction would be greatly appreciated.