Sentinel1981
Member
Hey gang, I finally got into the 4 mx 7000 bars I recently acquired, three 48" and one 52". On the first one I dug into, I noticed that several wires are very brittle, with one showing copper, and the bundle is very short. Obviously, it would be smart to replace the wires. I rewired my classic car, so I thought to myself would it be wise to rewire the whole bar? I know the correct gauge wire would need to be used, but has anyone done anything like that on these bars? I'm curious cause I would be replacing all of it, not just the brittle ones. I don't know if that would cause any issues in the future. Probably changing some rotator motors too.